ProExtender Ultimate Big Extension Rods Set

The big extension rod set, which measures 2.24 inches in length, helps extend the length of the proextender penis extender traction device. Compatible with the ultimate & double deck models. Made of stainless steel material.

Reaching a point where your traction device frame is fully compressed means your physical conditioning routine is working—but it also means you’ve hit a mechanical wall. If you run out of rod height, your device can no longer compress its internal springs to generate the necessary pulling force. Instead of stalling your progress or attempting to awkwardly stack too many tiny, unstable spacer blocks together, upgrading to a pair of primary long bars is the safest way to extend your frame tracking.

Whether you call them long metal side bars, primary extension pins, or heavy-duty traction rods, this Ultimate Big Extension Rods Set provides the structural foundation required to continue your routine smoothly.

As you can see in image, this direct manufacturer component consists of a pair of high-polish, heavy-duty metal tracking rods. They feature precision-engineered male threads at the top and deep female sockets at the bottom, allowing them to integrate flawlessly into your existing device frame to provide substantial, wiggle-free length progression.

Real Mechanical & Progression Issues This Rod Set Solves:

• Maxing Out Your Current Frame Height: When your starting rods become too short to provide adequate tension, your tissue remodeling stops. This “Big” rod set adds a significant block of continuous structural length to the frame, letting you dial the tension springs back down to a safe, comfortable starting point.

• Eliminating Wobbly, Multi-Piece Stacks: Threading four or five tiny micro-spacers together creates a lot of connection joints, which can cause the side bars to flex, bend, or warp under high tension. Replacing those small segments with a single pair of solid, continuous rods significantly increases the rigidity of the entire frame.

• Stripped or Cross-Threaded Connections: The metal threads on side rods endure constant counter-pressure from the internal calibration springs. If your old bars have stripped out, cross-threaded, or no longer screw together tightly, this fresh factory set ensures a rock-solid, completely secure lock.

• Replacing Missing Main Hardware: Because these rods are completely removed during deep cleaning or when adjusting your setup, a single rod can easily roll off a nightstand or get lost during travel. This matching pair ensures your device remains perfectly symmetrical and level.

FAQ

Q: Will these rods screw into my existing traction base?

A: Yes. These are authentic manufacturer parts for the ProExtender system. They feature the standard thread pitch used across the entire system. They screw directly into your lower spindle rod adjustment wheels or your existing mid-tier hex spacers without requiring any adapters or tools.

Q: How do I install this extension set onto my frame safely?

A: Installation is simple and completely tool-free. Remove your upper front plastic cradle and unscrew your old, shorter side bars. Twist the threaded male ends of these new big extension rods  directly into your frame tubes by hand until they sit completely flush and tight. Re-attach your front plate, and your expanded frame is ready to use.

Q: How do I clean high-polish metal components?

A: Maintenance is straightforward since the solid metal construction resists moisture and body oils. Wash the rods after your sessions using warm water and a mild antibacterial soap. It is vital to dry them thoroughly with a clean towel immediately afterward—never leave moisture sitting inside the threaded sockets, as keeping the threads bone-dry ensures they will screw together smoothly for years.